Bmw Members Exams With Answers
The reading on the micrometer shown above is ? - ANSWER- 6.5mm
What causes brake pulsation? - ANSWER- Variation thickness of brake rotor
A wheel bearing can cause a DSC fault. True or False? - ANSWER- True
3 wheel shows 24 miles and 1 is 23, what can be the cause? - ANSWER- Bad wheel
bearing
In a parallel circuit it shows three bulbs that aren't operating. What can be the cause ? -
ANSWER- Open from Y TO Z
An XDrive vehicle equipped with a transfer case makes a clunking noise during
accelerating and braking. What could be the cause? - ANSWER- Loose Chain
A vehicle comes in with a faulty differential. The fluid is overfilled and creamy, what
could be the cause? - ANSWER- Water in the fluid
A vehicle comes in with a concern of a clunking sound from the rear during a braking
and accelerating. What is the most likely cause? - ANSWER- Thrust Arm
A circuit shows a radio that is inoperative on the power outlet side. What could be the
cause? - ANSWER- Bad Fuse
A circuit shows the horn is inoperative. What could be the cause? - ANSWER- High
resistance on the clock spring
A vehicle has an overheated left front rotor during driving. What could be the cause? -
ANSWER- Seized front left caliper piston
DCS equipped vehicles use a system to choke or drop the RPM in the engine. True or
false? - ANSWER- True
On a DSC equipped vehicle, Technician A says it receives inputs from the steering
angle sensor. Technician B says it receives inputs from the brake switch. - ANSWER-
Both
DSC equipped vehicle deactivates traction when it's cold outside. True or false? -
ANSWER- False
0.1 ohms is shown at the injectors. What could be the cause? - ANSWER- Short injector
